Filter
Top Products
NOTE: When configuring in a DHCP network environment, enter the VSP temporary IP
address.
Figure 46 Set up systems Page
4. On the browser window, enter setupusr in the User Name box, and leave the password
box blank.
5. Click OK.
NOTE: The Service Processor Setup Wizard may not display correctly when using Microsoft
Internet Explorer 10 with default security settings. If the wizard continues to display incorrectly,
try refreshing the browser page.
Welcome Page
The Welcome page shows the information that is required to complete the wizard and set up the
SP. Follow the instructions on each screen, and then click Next.
The setup takes about 15 minutes.
You must have the following information:
• StoreServ 7-digit serial number
• SP network configuration:
The name to be assigned to the Service Processor◦
◦ IP address (IPv4 only)
◦ Subnet mask and gateway, if you are using custom settings
◦ DNS settings, if you plan to enable the Domain Name System
54 Setting Up the Service Processor and Storage System