Filter
Top Products
2-6
Installing the Switch
Installation Procedures
Installing the Switch
1. Connect the power cord supplied with the switch to the power connector
on the back of the power supply, and then into a properly grounded
electrical outlet.
Figure 2-2. Connecting the power cord.
Note The Series 6600 Switches do not have a power switch. They are powered on
when the power cord is connected to the power supply and to a power source.
For safety, the power outlet should be located near the switch installation.
The power supply cannot be removed when the power cord is connected.
The switch automatically adjusts to any voltage between 100-127 and 200-240
volts and either 50 or 60 Hz. No voltage range settings are required.
If your installation requires a different power cord than the one supplied with
the switch, be sure to use a power cord displaying the mark of the safety
agency that defines the regulations for power cords in your country. The mark
is your assurance that the power cord can be used safely with the switch.
2. Check the LEDs on the switch as described below. When the switch is
powered on, it performs its diagnostic self test. Self test takes approxi-
mately 50 seconds to complete.