Filter
Top Products
3 Troubleshooting Your PC Workstation
Using HP MaxiLife to Diagnose Problems
76 English
POST Phase
Following these checks, the POST (Power-On Self Test) sequence is
initiated. One of the following screens will appear in this phase:
Other Features
HP MaxiLife can also be configured to:
•
Display the configuration details of your PC Workstation required to
obtain support (System info.)
•
Indicate POST (Power-On Self Test) steps during the power-on
phase (Boot steps)
•
Perform diagnostic tests on your PC Workstation’s various hardware
components and display the results (Diags).
To configure your HP LCD:
1 Ensure that your PC Workstation’s power cord is connected to a
grounded outlet.
In this state, your PC Workstation’s hardware management chip is
active, even if your system is not powered on.
2 Press one of the LCD control buttons. The following menu is
displayed.
3 Use to scroll down through the menu items and to select the
required menu item.
No errors occurred.
A POST error occurred. Refer to “If a POST
Error Message is Displayed” on page 61 for
more information.
Error!
POST XXXX
HP KAYAK XU
System info
Boot steps
Next Go
Diags
Exit
Next Go
crystal.bk : cryst-3.fb4 Page 76 Monday, March 23, 1998 4:09 AM