Filter
Top Products
19
Signal Searching
Selecting The Aspect Ratio
1
Press the SEARCH button.
Cycle through input signals, displaying the images of retrieved signals. If
no signal is found, returns to the signal that was selected before the search
was begun.
• May not function properly with some input signals.
• The signal searching function takes about 10 seconds to display an image.
NOTE
• The temporarily blanking function will automatically finish if a button of the remote control
except the , , , , ENTER, ESC, RESET or ON button is pressed, or if a button of
projector is pressed, or if there is a change in the input signal’s state.
NOTE
COMPUTER VIDEO S-VIDEO
COMPONENT VIDEO
SEARCH
SRC
VIDEO
VSVC
WIDEAUTO
MUTE
BLANK
CUSTOM
CINEMA
AT
DYNAMIC NORMAL
WID
PC
VOLUME
COMPUTER
COMPONENTS-VIDEO
OFF
ON
SEARCH
SRC
VIDEO
VSVC
WIDEAUTO
MUTE
BLANK
CUSTOM
CINEMA
AT
CIN
M1
E
DYNAMIC
DYN
ENT
MYMEMORY
NORMAL
NOR CUS
WID
PC
MENU
ENTER
ESC RESET
VOLUME
COMPUTER
COMPONENTS-VIDEO
OFF
ON
KEYSTONE
M2 M3 M4
WIDEAUTO
MUTE
BLANK
CUSTOM
CINEMA
AT
CIN
M1
DYNAMIC
DYN
MYMEMORY
NORMAL
NOR CUS
WID
PC
MENU
KEYSTONE
M2 M3 M4
SEARCH
1
• At a COMPONENT VIDEO input of 16:9 Hi-Vision of 1125i
(1035i/1080i)/750p, only 16:9 can be selected.
• At a COMPUTER input, selecting an aspect ratio may display the
message “SYNC IS OUT OF RANGE”. In this case, please select one of
other aspect ratios.
WIDE
COMPUTER input
VIDEO, S-VIDEO, COMPONENT VIDEO input
Press the WIDE button.
4:3 16:9 15:9 32:15
4:3 16:9 WIDE MOVIE-1 MOVIE-2
Temporarily Blanking The Screen
1
Press the BLANK button.
The input signal screen is shut off, and a blank screen appears. You can
set the blank screen using the menu (from the SCREEN menu,
select BLANK).
Press the BLANK button again to remove the blank screen,
and return to the input signal screen.
BLANK
Operating (continued)