Filter
Top Products
45
The projector connected to an access point by a LAN cable
3.5 Manual conguration (continued)
SSID: WirelessAccessPoint (example)
Encryption: WEP64bit (example)
Encryption key *2:
**********
(example)
Mode: INFRASTRUCTURE
2) Click [Next].
3) Enter the following information that is set in
the projector. *3
IP Address : 192.168.1.10 (example)
Subnet mask: 255.255.255.0 (example)
4) Click [Connect].
5) The wireless connection will be established.
Proceed to the item 3.6 Conrm the connection to your destination. (50)
1) The setting on the access point.
*1
Enter the following information.
3. Using the Live Mode
*1 Contact the network administrator to nd out the setting on the access point.
*2 If you use an encryption, you need to set it. Contact the network administrator
to check the encryption key that is set in the projector.
The encryption key is always shown as “
**********
”.
*3 To nd the network setting on the projector, refer to the NOTE. (40)