Filter
Top Products
Reboot
When the Windows desktop is displayed or an application begins, the power up (or reboot) sequence is complete.
Warm Boot
Start > Run
The Warm Boot function refreshes the Windows operating system without clearing RAM or deleting installed programs. User-
set parameters are unchanged.
Tap Start > Run and type WARMBOOT.EXE or WARMBOOT. This command is not case sensitive.Tap the OK button. This
process takes less than 15 seconds. Temporary data not saved is lost.
Note: There may be slight delays while the wireless client connects to the network, re-authorization for voice-enabled
applications completes, Wavelink Avalanche management of the VX6 startup completes, or Bluetooth relationships
establish or re-establish.
Cold Boot
Start > Run
The Cold Boot function reboots the device, erases all registry data, and user-specified settings. The factory default settings are
restored when the VX6 powers on again.
Passwords are lost upon cold boot. If a password is set, that password must be entered to begin the cold boot power cycle
process.
Tap Start > Run and type COLDBOOT.EXE or COLDBOOT. This command is not case-sensitive
1
. Tap the OK button. This
command is located in the \Windows folder.
Note: Because of the extreme nature of cold boot, Honeywell recommends using this command only as an emergency (or
when instructed to do so as part of a specific VX6 procedure).
1
The text typed in the text box can be upper or lower case or a combination of upper and lower case letters.
2-12