Honeywell 7180 Barcode Reader User Manual


 
INSTALLATION
Full Speed USB
1. Turn off the host device.
2. Plug the male 10-pin RJ45 end of
the USB cable into the 10-pin
socket on the 7180.
3. Plug the other end of the USB
interface cable into the host
device’s USB port.
4. Turn on the host device.
When the scanner first receives
power, the blue and white LED
will toggle on and off then the
scanner will beep once.
As a default, the MS7180-38 leaves the factory with USB Keyboard
Emulation Mode enabled. Scan the following bar code to configure
the MS7180-38 for USB Serial Emulation Mode.
³ 3 1 6 4 6 0
Plugging the scanner into the USB port of the PC does not guarantee
that scanned information will appear at the PC. A software driver and
the correct configuration settings are also required for proper
communication to occur.
For Previous User’s of the 7120 Orbit* with an MX009:
The following bar code must be scanned in order for the new
integrated USB 7180 OrbitCG to function with the same serial
emulation driver as the old external USB 7120.
³ 3 1 6 4 7 0
* Orbit models before the 7120 rev L.
Figure 13.
11