Filter
Top Products
14 - 3
Power Supply
The base includes a power supply that contains a power adapter to ensure the proper voltage. The power
adapter is plugged into standard AC/DC outlets. Use only UL listed power supply, which has been
qualified by Honeywell, with output rated at 9.5V and 8.8 amps with the device..
Supplying Power
1. Be sure the power switch on the power adapter is in the OFF position.
2. Plug the power cord into the power adapter.
3. Plug the power connector cable into the power connector on the back panel of the base.
4. Plug the power cord into a standard wall outlet.
5. On the power adapter, turn the power switch to the ON position. The LEDs illuminate as the base
powers up.
6. The base is ready to begin charging terminals.
Inserting and Removing Terminals
Ensure all components are dry prior to mating terminals/
batteries with peripheral devices. Mating wet
components may cause damage not covered by the
warranty.
1. Slide the terminal into the well until the Dock LED
lights solid green.
2. Charging begins immediately.
Note: To remove a terminal, grasp it firmly in your hand and lift
it up and out of the terminal well. The LEDs turn off.
!