Filter
Top Products
7 - 14
Power
Power system settings contains two tabs: Battery and Advanced.
Note: You can also set automatic turn-off times for the terminal to conserve power. When the terminal is “turned
off,” that means that it goes into Suspend Mode, see Suspend Mode on page 3-15.
Regional Settings
Regional Settings enables you to customize the appearance and formatting to your geographic region.
Specifically, you can customize numbers (i.e., number of decimal places allowed), currency (i.e.,using the
$ or
€
€ symbol), time, and date. These specifications apply to all screens, including the Today screen. The
Region tab displays an overview of the region selected in the drop-down list at the top.
The terminal is loaded with a number of pre-programmed regional settings. Select one from the list and
the results appear on the screen. To see specific settings or to change a specific setting, tap on one of
the tabs, make the change, and tap OK to save it.
Remove Programs
Remove Programs enables you to remove programs installed on the terminal. Use this setting to
troubleshoot when you receive messages that the terminal is out of memory. The programs removed are
removed from RAM memory. Any program (usually CAB or DLL files) stored in the Autoinstall folder (My
Device > IPSM > Autoinstall) will re-install after the next hard reset.
For information about the hard reset process, see Hard Reset (Cold Boot) on page 3-15.
Battery Tab
For more information, see Batteries on page 3-12.
Note: The Backup Battery gauge registers either 0% or
100%. The percentage is not an indication of the
level of charge remaining on the backup battery.
An installed and functional battery registers 100%.
A total discharge or a battery error registers 0%."
Advanced Tab
Determines power time-outs.
For On battery power, select from the drop-down list,
the number of minutes of inactivity you want to pass
before the terminal powers off when running on battery
power.
For On external power, select from the drop-down list,
the number of minutes of inactivity you want to pass
before the terminal powers off when running on external
power.