Filter
Top Products
29
SCANNER OPERATION
IR ACTIVATION AREA (IR LED OUTPUT)
The StratosH’s default power save mode
†
is Dual Action Power Save Mode #2 (see page 34). This power save mode
†
turns the laser OFF after a configured period of non-use then turns the motor OFF after thirty-minute intervals. Any movement detected
by the IR in the activation area, shown below, will cause the scanner to exit the power save mode. The motor will restart automatically
and the laser will turn back on preparing the scanner for bar code recognition, decoding and transmission.
Figure 32. IR Activation Area Perpendicular to Package Flow (IR LED Output)
†
Refer to the MetroSelect Configuration Guide (00-02407) for additional information on configurable power save modes.
Specifications are subject to change without notice.