Filter
Top Products
8
Pole Display Configuration
The following bar codes can be used to configure a Single or Dual Cable
MS2xx0.
The MS2xx0 must be in scale program mode to use these bar codes.
Scale Has Display
³ 9 9 6 0 0 3
Set the scale to use a remote display to
show all scale activity.
A remote display must be plugged into the
Scale 46xx to Display connector on the
MS2xx0 (see Figure 7) for this feature to
function properly.
Figure 7. Location of Scale 46xx to Display Connector
Scale Has No Display
³ 9 9 6 0 0 4
Set the scale to not use a remote display.
All weights are expected on a POS terminal
display.
A remote display cannot be plugged into the
Scale 46xx to Display connector on the
scanner/scale (see Figure 7) or this feature
will not function properly.