81
Scanner Test Bar Codes
Supplemental Tests
Display Software Numbers
The following code does not require that the MS2xx0 to be in scale program
mode. This code is for test purposes only.
The following code will display software numbers on the 2-digit diagnostic
display. The lasers will be turned off while the numbers are being displayed.
The first number is the main decode processor software number. The second
number is the I/O processor’s software number. Since only 2 digits can be
displayed at a time, the following sequence is used as an example of what may
be observed:
2-Digit
Display
Description of each sequentially displayed sets of digits.
(Example shown will represent: ‘ 15269’ ‘ 15138’)
x 1
=
The first digit of the five main decode processor software number
appears right justified.
5 2 = The second and third digits.
6 9 = The forth and fifth digits.
x x
= Pause before next set of numbers.
x 1 =
The first digit of the five digit I/O processor software number
appears right justified.
5 1 = The second and third digits.
3 8 = The forth and fifth digits.
x = Blank / No Digit Displayed
After the last sets of digits are displayed, the scanner resumes scanning
operation. If the current interface does not use an I/O processor, the software
number may appear ‘ 0 00 00’. This capability exists in software 15269 and
later.
Display Software Number
³ 9 9 8 0 6 2