Filter
Top Products
9
USB (Powered by the Host Device)
1. Turn off the host device.
2. Plug the 15-pin socket end of the USB
cable into the 15-pin D-Type
connector on the MS4980
(see page 4).
3. Plug the USB end of the cable into the
host’s USB port.
4. Turn on the host device.
5. The MS4980 will start to initialize.
The white and blue LED will
alternately fade on and off for
approximately three seconds. When
the scanner has finished initializing,
the unit will flash the white LED three
times while simultaneously beeping
three times. The low intensity blue
LED will remain turned on. The
scanner will automatically reboot after
first initialization.
Installation Note
Plugging the scanner into a port on the host system does not guarantee that
scanned information will be communicated properly to the host system. Please
refer to the MetroSelect Single-Line Configuration Guide or MetroSet2’s help files
for instructions on changing the scanner’s factory default configuration. The
scanner and host system must use the same communication protocols.
See caution on page 5.
Figure 8.