Filter
Top Products
Vehicle Cradle Strain Relief Cable Clamp
Equipment Required: Phillips screwdriver (not supplied by Honeywell)
There are three strain relief cable clamps secured to the back of the vehicle cradle, located above the ports for the Serial
Interface, Power and MX7 I/O connections.
1. Remove the strain relief cable clamp from the back of the cradle by turning the screw counterclockwise. Put the screw
aside in a safe location.
2. Slide the strain relief clamp over the cable.
3. Using a Phillips screwdriver and the screw that was removed, refasten the clamp holding the cable to the vehicle cradle.
Do not stretch the cable. Leave enough slack in the cable to allow the cable to be connected and disconnected from the
MX7 Tecton easily when needed.
4. Continue in this manner until all cables are secured to the back of the vehicle cradle.
4-20