Filter
Top Products
User Manual
Aolynk S1505L Smart Ethernet Switch
Chapter 2
Installation
2-2
I.
2.2 Hardware Installation
Connect the cable
As shown in
Figure 2-1, you can use the console cable to connect
a PC to the S1505L. This cable takes an RJ-45 connector at one end
and a USB connector at the other end.
Figure 2-1 PC connection
II.
1) Plug the USB connector of the console cable into the USB
port of the PC that will be used to configure the S1505L.
2) Plug the RJ-45 connector of the console cable into the EXP
port of the S1505L.
Connect the power adapter
1) Attach one end of the power adapter to the power jack of the
S1505L and the other end to the external power socket.
2) Check the state of the Power LED. ON indicates the S1505L
is powered normally.
2.3 USB Driver Installation
After the above connections are completed, you must install the
USB driver on the PC according to the following procedure: