Filter
Top Products
Fiscal interface card
1. Remove the fiscal interface assembly from the printer (see “Fiscal interface
assembly” on page 6).
2. Remove the fiscal processor card (see “Fiscal processor card” on page 11).
3. Unscrew the four standoffs from the fiscal interface assembly.
Attention: Use a hex nut driver to unscrew the four standoff screws to avoid
bending the nearby connector pins on the interface card.
4. On the vertical part of the base of the fiscal interface assembly, remove the two
hex nuts, two lock washers, and two flat washers from the RS–232 port
connector.
5. Tilt and pull the interface card upwards until it is free from the fiscal printer card
assembly.
Figure 10. Removing Fiscal Interface Card from Housing
Removal and Replacement Procedures (GY27-0366) April 3, 2003
14 4610 - K
xx
Fiscal Printer Service Supplement