Filter
Top Products
Fiscal memory card
Attention: The memory card is permanently bonded to the fiscal interface
assembly. Removal of all FRUs from the fiscal interface housing is required before
replacing the memory card.
1. Remove the fiscal interface assembly from the printer (see “Fiscal interface
assembly” on page 6).
2. From the fiscal interface housing:
a. Remove the fiscal processor card (see “Fiscal processor card” on page 11).
b. Remove the CompactFlash (see “CompactFlash card assembly” on
page 12).
c. Remove fiscal interface card (see, “Fiscal interface card” on page 14).
d. Remove the keylock.
3. Using a new fiscal interface housing with the memory card, reassemble the
fiscal interface assembly.
4. Give the fiscal interface housing, with the memory card, to the proper authority.
5. After installing the assembled fiscal interface housing into the printer, place the
printer into service according to the local fiscal regulations.
Figure 11. Fiscal Memory Card
Removal and Replacement Procedures(GY27-0366) April 3, 2003
Chapter 2. SureMark printer service manual supplement 15