Filter
Top Products
23
DEUTSCH
ENGLISHFRANÇAISESPAÑOLITALIANOJAPANESECOMPL & WARR
2. Carefull
y
insert the head of a flathead (–) screwdriver into the slot visible
alon
g
either side of the cable cover (a) and pr
y
it off.
3. Squeeze the sides of the hin
g
e cover (b) and pull it off.
4. Gentl
y
lift the stand cover (c) alon
g
the top and then slide it backwards
and off the stand.
5. Remove the si
g
nal cable and the power cord from the monitor b
y
disconnectin
g
the correspondin
g
adapters. Carefull
y
cut the plastic tie to
free the power cord and remove the screw holdin
g
the power cord
clamp.
6. La
y
the monitor facedown on a cushion and remove the six screws
holdin
g
the hin
g
e mechanism on the monitor. Lift off the hin
g
e and base
assembl
y
.
7. If
y
ou are installin
g
an arm or wall-mountin
g
device, follow the directions
included with the device. If
y
ou are just chan
g
in
g
y
our cables, continue
with Step 8.
8. Connect the si
g
nal cable and the power cord, then refit the power cord
clamp in its ori
g
inal screwpost.
9. Slide the stand cover back on the stand.
10. Put the hin
g
e cover back on, makin
g
sure that the strai
g
ht side is at the
top.
11. Insert the three tabs at the top of the cable cover into the slots in the
back of the monitor and push the cover into place.
To obtain the correct cables and/or to
g
et further instructions on installin
g
them, call the IBM HELPCENTER at the above numbers or contact
y
our
dealer, retailer, or other IBM authorized Servicer.
b
c
a
T54A-E.book Page 23 Saturday, February 19, 2000 12:05 PM