Filter
Top Products
Use this service aid to display and change the following settings for the Surveillance
Policy.
Note: Because of system capability, some of the following settings might not be
displayed by this service aid:
Surveillance (on/off)
Surveillance Time Interval
This is the maximum time between heartbeats from the operating system.
Surveillance Time Delay
This is the time to delay between when the operating system is in control and
when to begin operating system surveillance.
Changes are to Take Effect Immediately
Set this to Yes if the changes made to the settings in this menu are to take place
immediately. Otherwise, the changes take effect beginning with the next system
boot.
You can access this service aid directly from the AIX command line, by typing:
/usr/lpp/diagnostics/bin/uspchrp -s
Create Customized Configuration Diskette
This selection invokes the Diagnostic Package Utility Service Aid, which allows the
user to create a standalone diagnostic package configuration diskette.
The Standalone Diagnostic Package Configuration Diskette allows the following to be
changed from the console:
Default refresh rate for a low function terminal (LFT)
The refresh rate used by the standalone diagnostic package is 60Hz. If the
display's refresh rate is 77Hz, then set the refresh rate to 77.
Different async terminal console
You can create a console configuration file that allows a terminal attached to any
RS232 or RS422 adapter to be selected as a console device. The default device
is an RS232 tty attached to the first standard serial port (S1).
Chapter 6. Introducing Tasks and Service Aids 119