Filter
Top Products
Run Diagnostics
The Run Diagnostics task invokes the Resource Selection List menu. When the
commit key is pressed, diagnostics are run on all selected resources.
The procedures for running the diagnostics depends on the state of the diagnostics
run-time options. See “Display or Change Diagnostic Run-Time Options” on
page 123.
Run Error Log Analysis
The Run Error Log Analysis task invokes the Resource Selection List menu. When
the commit key is pressed, Error Log Analysis is run on all selected resources.
Run Exercisers
Note: The Run Exercisers task is only supported in Online Maintenance Mode on
CHRP systems.
This task provides a tool to troubleshoot intermittent system problems on AIX Version
4.3.2 or later. This task provides an exerciser supervisor that controls the selected
exercisers.
When you select Run Exercisers from the Task Selection menu, the EXERCISER
SELECTION menu displays. Select the exerciser you want to run. Each exerciser
has other menus to set options for that exerciser.
Exerciser Commands (CMD)
Use the following commands as needed in the exerciser menus and reports. Not all
commands are available in each menu or report.
CMD Description
a Acknowledge an error
b Back one page
c Toggle between cycle count and last error
e View the AIX error log
f Page forward one page
q Return to Main Menu
r Refresh screen.
s Enable or disable beep on error
x Exit system exerciser
Chapter 6. Introducing Tasks and Service Aids 141