For some models, you need to apply two FCC labels. Check the old base cover; if it has two FCC labels,
apply both to the new base cover.
2010 LCD unit
For access, remove these FRUs in order:
• “1010 Battery pack” on page 50
• “1020 Bottom slot cover” on page 51
• “1040 Hard disk drive or solid state drive assembly” on page 53
• “1070 Keyboard” on page 57
• “1090 Top case assembly” on page 60
• “1130 System board assembly, fan assembly, and backup battery” on page 65
Table 27. Removal steps of LCD unit
In step1, release the antenna cables from the cable guides.
1
1
1
1
1
1
1
1
When installing:
• Make sure that the cables are attached to the cable guides rmly.
• When you route the cables, make sure that they are not subjected to any tension. Tension could cause the cables
to be damaged by the cable guides, or a wire to be broken.
Chapter 8. Removing and replacing a FRU 71