Filter
Top Products
27
Replacing the projection lamp
The lamp hour timer in the Service Info menu counts the number of hours
the lamp has been in use. Twenty hours before the specified end of the
lamp’s life, the message “Replace lamp” briefly appears on the screen at
each startup. When the expected lamp life has been reached, the Lamp indi
-
cator icon lights red.
NOTE: You can order new lamp housings from www.infocus.com (in select
areas), your retailer or your dealer. Only InFocus lamps are tested and certi
-
fied for use in this projector. InFocus is not liable for the performance, safety
or certification of any other lamps. The use of other lamps violates the pro-
jector warranty and voids all certification marks on this projector.
1 Turn off the projector and unplug the power cable.
2 Wait 60 minutes to allow the projector to cool thoroughly.
3 Turn the projector upside down and loosen the captive screw on the
lamp door. The lamp door is part of the lamp housing.
4 Insert the screwdriver in the tab on the lamp door and pry the door up.
WARNINGS:
• To avoid burns, allow the projector to cool for at least 60 minutes before
you replace the lamp.
• Only InFocus lamps are tested with this projector. Use of other lamps
may cause electrical shock and fire.
• Unplug the power cord before replacing the lamp.
• Do not drop the lamp module. The glass may shatter and cause injury.
• Do not touch the glass lamp screen. Fingerprints can obscure projection
sharpness.
Service Info menu
turn off and unplug
the projector
wait 60 minutes
loosen the screw on lamp door
pry the lamp door off
tab