Filter
Top Products
22
Using the remote control
The remote uses two (2) provided AA batteries. You can install the batteries
by removing the cover from the remote’s back, aligning the + and - ends of
the batteries, sliding them into place, and then replacing the cover.
Caution:
• When replacing the batteries, be aware that using batteries other than
the type provided with the projector may risk severe damage to the
remote. When disposing of the batteries, be sure to do so in an
environmentally proper manner.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• Ensure the batteries’ polarity (+/-) is aligned correctly.
• Do not mix new and old batteries together, or different types of
batteries together.
• Replace the batteries as soon as they run out.
• Remove batteries from the remote control when storing or not in use
for a prolonged period.
To operate, point the remote at the projector (not at the computer). The
range of optimum operation is about 30’ (9m).
Press the remote’s Power button to turn the projector on and off (see page 14
for shutdown information).
Press the remote’s Menu button to open the projector’s menu system. Use
the arrow buttons to navigate, and the Select button to select features and
adjust values in the menus. See
page 26 for more information on the menus.
The remote also has:
• Help button to access the projector’s help feature (see page 32).
• Volume buttons to adjust the sound.
• Custom button that can be assigned to a special function, like Blank
Screen or Freeze (see
page 29).
• Source button to switch between sources.
• Blank button to blank the screen.
• Presets button to select stored settings (see page 27).
• Mute button to silence the audio.
• Auto Image button to resynchronize the projector to the source.
• Resize button to switch among aspect ratios (see page 27).
Troubleshooting the remote
• Make sure the batteries are installed in the proper orientation and are
not dead.
• Make sure you’re pointing the remote at the projector or the screen, not
the computer, and are within the remote range of 30’ (9m). For best
results, point the remote at the projector.
Navigation
buttons