Filter
Top Products
Installation Instructions PRJ-WALLKIT-13
Visit the InFocus support site at www.infocus.com/support 11
Adjustments
Height Adjustment
1. Loosen two Phillips screws (one on left, one on right). (See
Figure 17)
2. Turn the button head cap screw on top of mount clockwise
to raise the mount (counterclockwise to lower the mount).
(See Figure 17)
3. Tighten two Phillips screws. (See Figure 17)
Pitch Adjustment
NOTE:
Use a level to make this process easier.
4. Loosen two Phillips screws (one on right, one on left). (See
Figure 17)
5. Tip up or down, as required.
6. Tighten two Phillips screws. (See Figure 17)
Roll Adjustment
NOTE:
Use a level to make this process easier.
7. Loosen one Phillips screw. (See Figure 17)
8. Adjust horizontal tilt, as required.
9. Tighten one Phillips screw. (See Figure 17)
Side-to-Side Adjustment
10. Loosen four Phillips screws (two on front, two on back).
(See Figure 17)
11. Adjust side-to-side, as required.
12. Tighten four Phillips screws. (See Figure 17)
Figure 17
10
11 12
7
8
9
x 1
4
5 6
x 2
1
x 2
2
OR
x 1
(lower)
(raise)
3
x 4