Intel FSB533 Computer Hardware User Manual


 
BIOS
Page 4-31
4-10 Supervisor/User Password Setting
These items are used to install a password. A Supervisor password takes prece-
dence over a User password, and the Supervisor limits the activities of a User.
You can set either a supervisor or user password, or both of them:
Supervisor password: authorized to enter and change the options of the setup
menus.
User password: authorized to enter, but not authorized to change the
options of the setup menus.
When you select Set User/Supervisor Password, the following message appears
prompting you to type a password:
ENTER PASSWORD:
Type the password, up to eight characters in length, and press <Enter>. The password
typed now clears any previously entered password from CMOS memory. You will be
prompted to confirm the password. Type the password and press <Enter>. You may
also press <Esc> to abort the selection and not enter a password.
To disable a password, press <Enter> when you are prompted to enter the password.
A message will confirm the password is disabled:
PASSWORD DISABLED.
Once the password is disabled, the system will boot and you can enter Setup freely.
When a password has been enabled, you will be prompted to enter it every time you
try to enter Setup. This prevents an unauthorized person from changing any part of
your system configuration.
Additionally, when a password is enabled, you can also require the BIOS to request
a password every time your system is rebooted. This prevents unauthorized use of
your computer.
You determine when the password is required within the BIOS Features Setup menu
Security option. If the Security option is set to System, the password will be
required both at boot and at entry to Setup. If set to Setup, prompting only
occurs when trying to enter Setup.