L440GX+ Server Board Product Guide 29
3. If your server has one processor and you are REPLACING it, leave the termination board intact
in the empty secondary slot. Remove the processor you want to replace. See “Removing a
Processor” on page 26.
4. If your server has two processors and you are REPLACING one or both, remove the
appropriate one(s). See “Removing a Processor” on page 26.
5. Remove the new processor from its antistatic package and place it on a grounded, static free
surface or conductive foam pad.
6. Orient the processor so that the heat sink faces the I/O connectors. Slide the processor into the
retention mechanism. Push down firmly, with even pressure on both sides of the top, until the
processor is seated.
7. Attach the small end of the power cable to the fan connector on the S.E.C. cartridge, then attach
the large end to the 3-pin connector on the server board.
8. After you have installed the processor, you must configure its speed in BIOS set-up.