Filter
Top Products
3
Connect the Network Cable
1 Connect a single network cable to the PRO/100B TX PCI adapter as
shown below. For 100BASE-TX, your network cable must be four-pair,
category 5, twisted-pair wiring. If you plan on running the adapter at 100
Mbps, it must be connected to a 100BASE-TX hub (not a 100BASE-T4
hub). For 10BASE-T, use two-pair wiring.
Twisted Pair Ethernet (TPE).
Use category 5 cable and RJ-45
connector for this adapter. Do not
use category 3 wiring. At 100
Mbps, connect to a TX hub, not a
T4 hub. For full duplex, see
instructions on page 11.
100BASE-TX Wiring
NOTE:
For more information on 100BASE-TX wiring requirements and limita-
tions, see page 18 in this guide and refer to the README files on
the installation disk.
2 To configure the adapter, continue with the procedures specific to your
operating system on pages 4 through 10:
• DOS and Windows 3.1 users with NetWare, go to page 4
• Windows NT 4.0 and 3.5x users, go to page 6
• Windows 95 users, go to page 8
• Others, go to page 10