Filter
Top Products
Installing Red Hat* Enterprise Linux 4*
Intel® Server Board S5000PAL
19
Installing from a Hard Drive
1) The Select Partition screen applies only if you are installing from a disk partition (that is, if you
selected Hard Drive in the Installation Method dialog). This dialog allows you to name the disk
partition and directory from which you are installing Red Hat Enterprise Linux.
Figure 4-3 Selecting Partition Dialog for Hard Drive Installation
2) Enter the device name of the partition containing the Red Hat Enterprise Linux ISO images. There is
also a field labeled Directory holding images.
3) If the ISO images are in the root (top-level) directory of a partition, enter a /. If the ISO images are
located in a subdirectory of a mounted partition, enter the name of the directory holding the ISO
images within that partition. For example, if the partition on which the ISO images is normally
mounted as /home/, and the images are in /home/new/, you would enter /new/.
4) After you have identified the disk partition, the Welcome dialog appears.
Performing a Network Installation
1) If you are performing a network installation, the Configure TCP/IP dialog appears. This dialog asks
for your IP and other network addresses. You can choose to configure the IP address and Netmask
of the device via DHCP or manually. If manually, enter the IP address you are using during installation
and press [Enter]. The installation program attempts to guess your Netmask based on your IP
address; you may change the netmask if it is incorrect. Press [Enter]. The installation program
guesses the Default gateway and Primary nameserver addresses from your IP address and netmask;
you may change them if they are incorrect.
Installing via NFS
1) The NFS dialog applies only if you are installing from an NFS server (if you selected NFS Image in
the Installation Method dialog).