Filter
Top Products
Installing Red Hat* Enterprise Linux 4*
Intel® Server Board S5000PAL
40
2) Once you have selected a network device, click Edit. From the Edit Interface pop-up screen, you can
choose to configure the IP address and Netmask of the device via DHCP (or manually if DHCP is not
selected) and you can choose to activate the device at boot time. If you select Activate on boot,
your network interface is started when you boot. If you do not have DHCP client access or you are
unsure what to provide here, please contact your network administrator.
Figure 4-15. Editing a network Device
Note: Do not use the numbers as seen in this sample configuration. These values will not work for
your own network configuration. If you are not sure what values to enter, contact your network
administrator for assistance.
If you have a hostname (fully qualified domain name) for the network device, you can choose to
have DHCP (Dynamic Host Configuration Protocol) automatically detect it or you can manually enter
the hostname in the field provided.
Finally, if you entered the IP and Netmask information manually, you may also enter the Gateway
address and the Primary, Secondary, and Tertiary DNS addresses.
Tip: Even if your computer is not part of a network, you can enter a hostname for your system. If
you do not take this opportunity to enter a name, your system will be known as localhost.
Tip: To change your network configuration after you have completed the installation, use the
Network Administration Tool. Type the system-config-network command in a shell prompt to launch
the Network Administration Tool. If you are not root, it prompts you for the root password to
continue.