Filter
Top Products
18 SBC-455 User's Manual
IDE hard drive connections (IDE)
You can attach two Enhanced Integrated Device Electronics hard
disk drives to the SBC-455's internal controller. The card comes
with a 40-pin flat piggyback cable. This cable has three identical
40-pin flat-cable connectors.
Connecting the hard drive
Wire number 1 on the cable is red or blue, and the other wires are
gray.
1. Connect one end of the cable to the IDE connector. Make sure
that the red (or blue) wire corresponds to pin 1 on the connec-
tor, which is labeled on the board (on the right side).
2. Plug the other end of the cable to the Enhanced IDE hard drive,
with pin 1 on the cable corresponding to pin 1 on the hard
drive. (See your hard drive's documentation for the location of
the connector.)
Unlike floppy drives, you can make the connections with any of
the connectors on the cable. If you install two drives, you will
need to set one as the master and one as the slave. You do this
using jumpers on the drives. If you install just one drive, set it as
the master.