Intel SHG2 Computer Hardware User Manual


 
Configuration Software and Utilities 69
8. From the Connection Mode list, choose either:
Direct Connect: the COM2 port on the server is connected by a serial cable to the remote
system.
Modem Connect: the COM2 port on the server is connected to a modem.
9. Click Save to save the changes.
10. Click Close to return to the PEM window.
FRUSDR Load Utility
The Field Replacement Unit (FRU) and Sensor Data Record (SDR) Load Utility is a DOS-based
program used to update the server management subsystems product level FRU, SDR, and the
SM BIOS (SMB) nonvolatile storage components (EEPROMs). The load utility
Discovers the product configuration based on instructions in a master configuration file
Displays the FRU information
Updates the nonvolatile storage device (EEPROM) associated with the Baseboard Management
Controller (BMC) that holds the SDR and FRU area
Updates the SMB area located in the BIOS nonvolatile storage device
Generically handles FRU devices that may not be associated with the BMC
When to Run the FRUSDR Load Utility
You should run the FRUSDR Load Utility each time you upgrade or replace the hardware in your
server, excluding add-in boards, hard drives, and RAM. For example, if you replace an array of
fans, you need to run the utility. It programs the sensors that need to be monitored for server
management.
Because the firmware must reload to properly initialize the sensors after programming, turn the
server off and remove the AC power cords from the server. Wait approximately 30 seconds, and
reconnect the power cords.
What You Need to Do
The FRUSDR Load Utility may be run directly from the Configuration Software CD or from a
diskette you create from the CD. It can be extracted from the CD by booting to the CD and
selecting Make Diskettes or by inserting the CD into a PC running Windows 95 or later and
selecting the Utilities section.
NOTE
If your diskette drive is disabled, or improperly configured, you must use
BIOS Setup to enable it. If necessary, you can disable the drive after you are
done with the FRUSDR utility.