Filter
Top Products
BIOS SETUP 37
- Any Key: Press any key to Power On the system.
- Button only: Power On only by pushing the button on the case (Default).
- Keyboard 98: You can Power On system by pushing the [Power-On] key of Keyboard 98.
• •
• •
• KB Power On Password
Enter the Power On Passward here. Activated only when “Password” item is selected
in the Power On Function Menu.
NOTE: If you want to use this function, please make sure that the “KB-AWK” jumper
is set to “Enabled”.
• •
• •
• Hot Key Power On
Choose [CTRL] +[ F1] ~ [F12] as a hot key to Power On the system. Activated only when
“Hot Key” is selected on the Power On Function Menu.
• •
• •
• Onboard FDC Controller
You can use this function to enable or disable the onboard FDC controller.
• •
• •
• Onboard Serial Port 1/Port 2
Select an address and the corresponding interrupt for each of the first and second serial
ports. The choices are: “Disabled”, “3F8/IRQ4”, “2F8/IRQ3”, “3E8/IRQ4”, “2F8/IRQ3”, and
“Auto”. The second serial port shares the resources (address and IRQ) with IrDA.
• •
• •
• UART Mode Select
Choose the right type of infrared device:
- Normal: Normal operation
- IrDA: IrDA compliant serial infrared port
- ASKIR: Amplitude Shift Keyed Infrared Port
• •
• •
• RxD, TxD Active
Consult your IR peripheral documentation to select the combination of RxD and TxD.
• •
• •
• IR Transmission Delay
Consult your IR peripheral documentation to select “Enabled” or “Disabled” for the IR
Transmission Delay.
• •
• •
• UR2 Duplex Mode
This item allows you to select the IR half/full duplex function.