Filter
Top Products
A p p e n d i c e s
I n t e r m a t e L X T - 0 4 57
C. Operating the LX T-04
The SYSTEM indicator
This indicator (green) is lit when the Intermate LX T-04 is connected to your
IBM system. It can also flash under the following conditions:
Flash during a few seconds at power up.
Flash in Test Mode. Described later in this chapter.
Rapid flash during test function execution and during flash loading
of new software.
Note: If the power up flashing continues, a hardware error has occurred.
Contact your dealer/ distributor.
The Address Switch
The ten-position address switch is used to set the device address for the
Intermate LX T-04. It is also used to set start conditions and to select and
execute test functions during operation.
Start Conditions
The action when the Intermate LX T-04 is switched on is determined by the
setting of the address switch, as follows:
Pos. Description
0 - 6 Divice address in normal print operation.
7 Reserved.
8 Select IBM 4214 Printer emulation,
9 Perform a test printout.