Filter
Top Products
A p p e n d i c e s
I n t e r m a t e L X T - 0 4 59
Pos. Test Mode Function
0
Restart
- same as power off/power on.
1
Set Factory Defaults
- abandon the current configuration. See note.
2
Print Character Translation Table
- see
Appendix B
.
3
ASCII Hex Dump Mode
- trap the outgoing data stream and print characters
and control commands as hexadecimal values.
4
System Hex Dump Mode
- trap the incoming data stream and print
characters and control codes as hexadecimal values.
5 Reserved.
6 Not used.
7
Terminal Set-up Mode
- run the Configuration Utility using a directly
attached 5250 terminal, see
Section 3
.
8
Print Parameter List
- print the complete configuration, see
Appendix A.
9
Exit Test Mode
- resume normal print operation.
Do not forget to set the address switch to the current device address again for
normal print operation. Switch the Intermate LX T-04 off and on.
Note: To set factory default configuration requires a two-step operation
to avoid accidental activation and loss of configuration settings:
1.
Set the address switch to position '1'.
2.
Within 2 seconds, set the address switch to position '2'.
Select IBM Printer Emulation
You can select IBM Printer Emulation by using the address switch. This
section applies to the IBM 4214 emulation only. Proceed as follows:
1.
Switch the Intermate LX T-04 off. Note the current device address.
2.
Select the position '8' on the address switch.
3.
Switch the Intermate LX T-04 on. A printed message indicates the current
IBM Printer Emulation.