Filter
Top Products
2525
2525
25
BIOS SETUP UTILITY
CPU Configuration
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
v02.54(C) Copyright 1985-2003, American Megatrends, Inc.
Advanced
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
CPU Frequency (MHz)
PCIE Frequency (MHz)
Overclock Mode
[200]
[100]
[Auto]
CPU Spread Spectrum
PCIE
SATA
HT
Cool'n'Quiet
Spread Spectrum
Spread Spectrum
Spread Spectrum
[CenterSpread]
Enabled
Enabled
[Enabled]
[]
[CenterSpread]
[]
Processor Maximum Multiplier
Processor Maximum Voltage
Memory Clock
Flexibility Option
Bank Interleaving
Burst Length
CAS Latency (CL)
TRCD
TRAS
[Auto]
[4 Beats]
[Auto]
[Auto]
[Auto]
[Disabled]
[Auto]
x11
1.550 V
Boot Failure Guard
[Enabled]
Multiplier/Voltage Change
[Auto]
If AUTO, multiplier and
voltage will be left at the
rated frequency/voltage. If
Manual,
will be set based
on UserSelection in Setup.
multiplier and
voltage
BIOS SETUP UTILITY
Main
H/W Monitor Boot Security Exit
Advanced Settings
WARNING: Setting wrong values in below sections
may cause system to malfunction.
Options for CPU
Select Screen
Select Item
Enter Go to Sub Screen
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
v02.54(C) Copyright 1985-2003, American Megatrends, Inc.
Advanced
CPU Configuration
Chipset Configuration
ACPI Configuration
IDE Configuration
PCIPnP Configuration
Floppy Configuration
SuperIO
USB Configuration
Configuration
3.33.3
3.33.3
3.3
Advanced ScreenAdvanced Screen
Advanced ScreenAdvanced Screen
Advanced Screen
In this section, you may set the configurations for the following items: CPU
Configuration, Chipset Configuration, ACPI Configuration, IDE Configuration, PCIPnP
Configuration, Floppy Configuration, SuperIO Configuration, and USB Configuration.
Setting wrong values in this section may cause
the system to malfunction.
3.3.13.3.1
3.3.13.3.1
3.3.1
CPU ConfigurationCPU Configuration
CPU ConfigurationCPU Configuration
CPU Configuration
Overclock Mode
Use this to select Overclock Mode. The default value is [Auto]. Cnfiguration
options: [Auto], [CPU, PCIE, Sync.] and [CPU, PCIE, Async.].
CPU Frequency (MHz)
Use this option to adjust CPU frequency. The range is from 140MHz to
300MHz. The default value is [200].