Filter
Top Products
■
One LC full duplex connector
■
Transmit power:
■
min: –2 dBm
■
max: 3dBm
■
Receive input power:
■
min: –22 dBm
■
max: –3 dBm
■
See the following corresponding table (ZX Fiber Optic Cabling) for cabling
requirements.
■
See E320 Hardware Guide, Chapter 5, Cabling the Router for more information.
Cables and connectors
(single-mode [ZX])
Board-level LEDs:
■
OK (green)—IOA is online and is functioning properly
■
FAIL (red)—Failure detected
Port LEDs:
■
LK (green)—Ethernet link is up
■
ACT (green)—Blinks when Ethernet traffic is being received
LEDs
■
See Monitoring Ethernet Interfaces in JUNOSe Physical Layer Configuration Guide,
Chapter 5, Configuring Ethernet Interfaces.
Alarms, errors, and events
Table 6: SX Fiber Optic Cabling
Maximum Operating Range (meters)Minimal Modal Bandwidth at
850 nm (MHz*km)
Fiber Type
220 (656.17 ft)16062.5 microns
275 (902.23 ft)200
500 (1640.42 ft)40050 microns
550 (1804.46 ft)500
Table 7: LX Fiber Optic Cabling
Maximum Operating Range
(kilometers)
Nominal Wavelength (nm)Fiber Type
10 (6.2 miles)13109 microns
Table 8: LX40 Fiber Optic Cabling
Maximum Operating Range
(kilometers)
Nominal Wavelength (nm)Fiber Type
24 ■ GE-8 IOA
E320 8.1.x Module Guide