Juniper Networks ERX-1440 Network Router User Manual


 
Telnet Setup
ERX Edge Routers
5-5
The system is now in Privileged Exec mode.
2 Enter the configure command.
host1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#
The system is now in Global Configuration mode.
3 Enter the line command.
host1(config)#line vty 0 4
host1(config-line)#
The system is now in Line Configuration mode.
4 Disable the password.
host1(config-line)#no login
Note: In this example, you disabled the password requirement, but you can
choose to set a password instead. See the ERX System Basics Configuration
Guide, Chapter 6, Passwords and Security for information on setting a password.
5 Run Telnet from the management console (on the same Ethernet
network as the system).
6 Enter the IP address of the system to open the Telnet session.
The User Exec prompt appears when the Telnet session to the system
is established.
host1>
7 Enter the enable command.
host1>enable
host1#
The system is now in Privileged Exec mode.
8 Enter the configure command.
host1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#
The system is now in Global Configuration mode, from which you
can configure the system. See ERX System Basics Configuration
Guide, Chapter 2, Command Line Interface.