Filter
Top Products
14
Basic Operations
Daily Operations
1
Turn on the main power.
Set POWER on the back of the Monitor to ON.
The POWER lamp on the upper left of the front panel
glows orange.
2
Turn on the power.
Press POWER on the remote control to turn the power on.
The POWER lamp changes to glow green.
• You can also use the POWER on the front panel (lower
right) to turn on the Monitor.
3
Select an input.
Select the desired input by pressing VIDEO A, VIDEO B,
COMPO./RGB B and RGB A.
• You can also select the input by pressing INPUT on the
Monitor. Each time you press the button, the input
mode changes in sequence.
Note:
• To select “COMPONENT” or “RGB B,” you need to set the
“RGB/COMPO.” setting correctly.
4
Adjust the volume.
Note:
• While no menu is displayed, you can adjust the volume by
pressing 2 / 3 on the Monitor.
To turn off the volume immediately
Press MUTING.
“MUTING ON” is displayed, and the sound goes out.
Pressing the button again resumes the previous volume level.
To make the screen indication appear
Press DISPLAY.
The types of input and signal are indicated on the screen for
about 3 seconds.
You can also make the screen indication appear using menus
(page 24).
VIDEO A VIDEO B
RGB A COMPONENT or RGB B
POWERAC INOPTIONAUDIO
L
OUT
R
RGB A
AUDIO
IN
REMOTE
RS-232C
WIRED
MAKE
SPEAKER OUT
9(
L
SPEAKER OUT
9(
R
VIDEO A
AUDIO
VIDEO
INOUT
MONO/L
R
VIDEO B
AUDIO
VIDEO
IN Y/C IN
MONO/L
R
COMPONENT/RGB B
AUDIO
VIDEO
Y/G Pb/B Pr/RHD/Cs VD
MONO/L
R
1
POWER
4
3
2
MUTING
DISPLAY
DISPLAY ASPECT POWER
RGB A
COMPO.
VIDEO BVIDEO A
MUTING
MENU/EXIT
RM-C576 REMOTE CONTROL UNIT
VOLUME
RGB B
Rear View
VIDEO A
NTSC
Input selected
Input video signal
Ex. When selecting “VIDEO A” input
: 10
VOLUME
+
–
14-23.GM-P420[US]f 02.4.1, 2:20 PM14