Filter
Top Products
29
Resetting All the Setup Menu Settings
You can reset all the following Setup Menu settings at a time,
except the use time of the source lamp (HOUR METER).
1
On the remote control:
Press MENU/EXIT while holding
VOLUME – to display the Setup Menu.
On the Monitor:
Press MENU while holding 2 to display
the Setup Menu.
2
Press 5/∞ to move the cursor (3) to
“reset” (on the second page).
• The Setup Menu consists of two pages. If you keep
pressing 5/∞, you can move to the other page from
the current page.
3
Press 3.
The confirmation screen appears.
4
Press 3 again to reset all the Setup
Menu settings.
To cancel the reset, press MENU/EXIT (or MENU on
the Monitor).
Cursor (3)
STATUS DISPLAY
CONTROL LOCK
REMOTE SWITCH
HD SIGNAL MODE
WHITE BALANCE
SET-UP MENU 1/2
ADJUST:
SELECT:
EXIT:
MENU
: OFF
: OFF
: MODE1
: 1080i
Cursor (3)
STATUS DISPLAY
CONTROL LOCK
REMOTE SWITCH
HD SIGNAL MODE
WHITE BALANCE
SET-UP MENU 1/2
ADJUST:
SELECT:
EXIT:
MENU
: OFF
: OFF
: MODE1
: 1080i
Are you sure?
"YES"
then key.
"NO" then key.
MENU
reset
PIXEL SHIFT
POWER SAVE
COLOR-REVERSE
REFRESH
reset
all reset
HOUR METER x100h
MODEL NAME
SET-UP MENU 2/2
: ON
: ON
: ON
: ON
: 001
: GM-P421U
PIXEL SHIFT
POWER SAVE
COLOR-REVERSE
REFRESH
reset
all reset
HOUR METER x100h
MODEL NAME
SET-UP MENU 2/2
: ON
: ON
: ON
: ON
: 001
: GM-P421U
PIXEL SHIFT
POWER SAVE
COLOR-REVERSE
REFRESH
reset
all reset
HOUR METER x100h
MODEL NAME
SET-UP MENU 2/2
: ON
: ON
: ON
: ON
: 001
: GM-P421U
2
Press 5/∞ to move the cursor (3) to
“COLOR-REVERSE” (on the second page).
• The Setup Menu consists of two pages. If you keep
pressing 5/∞, you can move to the other page from
the current page.
3
Press 2/3 to select “ON” while
showing the still picture so that you can
avoid the screen from being burned in
with the still picture.
Each time you press the button, the Color-Reverse
function alternates between “ON” and “OFF.”
To cancel the Color-Reverse function, select “OFF.”
4
Press MENU/EXIT (or MENU on the Monitor)
once to exit from the menu operations.
Refreshing the Screen
After the power is turned off, a whitish image may be left on
the screen. In that case, leave the monitor in a white back state
for a while, and the image will disappear.
1
On the remote control:
Press MENU/EXIT while holding
VOLUME – to display the Setup Menu.
On the Monitor:
Press MENU while holding 2 to display
the Setup Menu.
2
Press 5/∞ to move the cursor (3) to
“REFRESH” (on the second page).
• The Setup Menu consists of two pages. If you keep
pressing 5/∞, you can move to the other page from
the current page.
3
Press 2/3 to select “ON.”
The Setup Menu disappears, and the white screen appears.
To cancel the Refresh function
Repeat steps
1
and
2
, then select “OFF” by pressing 2/3.
24-30.GM-P420[US]f 02.4.1, 2:21 PM29