Filter
Top Products
6
Parts Identification (Continued)
Monitor: Rear Views
1 RGB A input terminals (page 11)
• D-sub, 15 pin
Connect to the video output terminal of a personal
computer.
• AUDIO IN (stereo mini jack)
Connect to the audio output terminal of a personal
computer.
2 REMOTE terminals (pages 11 and 13)
• RS-232C (D-sub, 9 pin)
Connect to the RS-232C terminal of a personal computer.
For the control method using this terminal, consult an
authorized JVC dealer.
• MAKE terminal (mini DIN 4pin)
Connect an external control unit. (See page 13.)
• WIRED terminal (stereo mini jack)
Connect a wired remote control unit to this terminal.
Note:
• When the above three terminals are used at the same
time, transmitted commands through the MAKE
terminal have priority over those through the other
terminals.
3 AUDIO OUT terminals (pin jack) (page 11)
Connect to the audio input terminals of external
equipment such as an amplifier.
4 OPTION terminal (page 13)
Connect the power cord of the Cooling Fan Unit (not
supplied) when installing the Monitor vertically.
5 AC IN terminal (page 11)
Connect the supplied power cord to this terminal.
6
POWER switch (page 14)
Setting this switch to
ON will put the Monitor into
standby mode, allowing you to turn on and off the power
using the POWER button either on the remote control or
on the Monitor.
7 SPEAKER OUT L/R terminals (page 11)
Connect external speakers.
POWERAC INOPTION
SPEAKER OUT
AUDIO
L
OUT
R
RGB A
AUDIO
IN
REMOTE
RS-232C
WIRED
MAKE
9( 9(
R
SPEAKER OUT
L
1 2 3 4 5 6
7
04-13.GM-P420[US]f 02.4.1, 2:18 PM6