Filter
Top Products
Setting up the Projector
3/99 23
Turning Off the Projector
If you want to turn off the projector for a short period of time,
press the button on the keypad or remote. This blanks the
screen for fifteen minutes, but keeps the projector running. (You
can change the amount of time the projector stays in standby
mode; see “Standby Time” on page 38 for details.) After 15
minutes, the lamp goes out (the projector keeps running). To exit
standby mode, press the button again. (It may take several
seconds for the projection lamp to reach full power and project
the image again.)
To completely power off the projector, press the “O” side of the
power switch on the side of the projector. If you want to turn the
projector back on immediately, you must allow about a minute for
the lamp to cool. The lamp won’t light if it’s too hot.
&DXWLRQ :KHQ\RXGLVFRQQHFWWKHSURMHFWRUDIWHU\RXKDYH
VZLWFKHGLWRIIDOZD\VUHPRYHWKHSRZHUFRUGIURP
WKHHOHFWULFDORXWOHWILUVWWKHQUHPRYHLWIURPWKH
SURMHFWRU