Filter
Top Products
Reference Manual KODAK DP900 / DP1100
22 3/99
Starting the Projector
Note: Always use the power cord that shipped with the projector.
1. Remove the lens cap.
2. Plug the power cord into the side of the projector, then plug it
into your electrical outlet. A surge-protected power strip is
recommended.
3. Turn on the projector by pressing the “I” side of the power
switch.
• The Kodak startup screen appears and the Power LED on
top of the projector lights up.
4. If you connected a video player, turn it on.
• The video image should display on the projection screen.
If a computer source is active, press the button
on the keypad (page 30) or the button on the remote
to display your video image. You can select a default
source to determine which source the projector examines
first during power-up for active video; see “Default
Source” on page 38.
• Use the
buttons to adjust the volume.
5. Turn on your computer.
• The computer image should display on the projection
screen. (If a video source is active, press the
button on the keypad (page 30) or the button on the
remote to display your computer’s image.)
Note: With some computers, the order in which you power up
the equipment is very important. Most computers should
be turned on last, after all other peripherals have been
turned on. Refer to your computer’s documentation to
determine the correct order.
• If necessary, make adjustments to the image from the
projector’s on-screen menus. To open the menus, press
the button on the keypad or remote, then select the
Display or Image sub-menu. For more information about
the menus, see “Using the On-Screen Menus” on
page 31.