Filter
Top Products
A-61500 April 2007 5-17
Replacing the pre-
separation pad
Change the pre-separation pad when the frequency of double-fed
documents increases.
1. Open the pod.
2. Remove the pre-separation pad.
3. Install the new pre-separation pad. Be sure it snaps into place.
4. Close the pod.
Replacing the imaging
guides
The imaging guides should be replaced when they are heavily
scratched and defects show in the image.
NOTE: Handle the imaging guides carefully as to not put fingerprints on
the guides.
1. Open the pod.
2. Turn the screw on each end of the upper imaging guide to remove it
from its position.
3. Install the new imaging guide and turn the screws to secure the
imaging guide.
4. Repeat Steps 2 and 3 to replace the lower imaging guide.
5. Close the pod.