Konica Minolta MS6000 MKII Scanner User Manual


 
ii
Notes to Operators and Key Operators
The following safety rules should be observed:
[1]The unit should be kept free from moisture, dirt, dust and exposure to heat and direct sun-
light at all times.
[2] Keep hands, hair and clothing away from rollers and other moving parts.
[3]Before removing the Projection Lamp Unit, confirm that the machine is turned “OFF”.
[4]Be sure that the proper voltage is used and that the machine is well grounded. The use of
electrical extension cords is strongly discouraged.
[5]For best performance, only our authorized supplies are recommended for use with this
unit. Failure to use our authorized supplies may cause damage to the unit, in which case
the warranty may be rendered void.
[6]Do not attempt to remove any Cover that is secured.
FCC Part 15 - Radio Frequency Devices (For U.S.A. Users)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause un-
desired operation.
WARNING
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
The design and production of this unit conforms to FCC regulations, and any changes or
modifications must be registered with the FCC and are subject to FCC control. Any changes
made by the purchaser or user without first contacting the manufacturer will be subject to
penalty under FCC regulations.