Filter
Top Products
CHAPTER 7 WHEN A PROBLEM OCCURS
7-2
Indication
“A” and “011” alternate on the copy quantity
display.
“A” and “040”, “041” or “043” alternate on the
copy quantity display.
The Add Toner indicator lights.
“AP” appears on the copy quantity display.
“PF” appears on the copy quantity display.
“E07” appears on the copy quantity display.
“E30” appears on the copy quantity display.
Action
If this indication appears, turn the main switch OFF and ON. An error message
will automatically be printed out.
The copier initializes the data to remedy the error. Make the specifications
setting (F29 Inch/metric specifications setting) before using the copier again.
If the same indication appears again or if the same indication appears frequently,
contact your service representative.
The error message is as follows:
“Default data was initialized. Need initial setting to use the machine. Input F29:
User Code. cf. User manual.”
When you installed the memory copy board/DIMM, it was not installed correctly.
Check the installation of the memory copy board/DIMM and turn the main switch
OFF and ON. If the same indication appears when the memory copy board/
DIMM is installed correctly, remove the memory copy board/DIMM, print a user
status report and contact your service representative with the details on the
report.
Making copies is still possible, one at a time, for some time with the indicator lit
but copying will eventually be disabled. Replace the toner container and waste
toner tank as soon as possible.
* If you replace the toner container with the main switch turned OFF (O), the Add
Toner indicator may not go out. In this case, open and close the front cover.
Toner is being replenished inside the copier. Wait a few minutes.
* Although the lamp under the platen may remain lit while “AP” is displayed, it is
not a problem.
• A paper misfeed occurred in the drawer of the flashing indicator. Remove the
misfed paper.
• The drawer of the flashing indicator is not inserted correctly. Close the drawer
securely.
• There is no paper in the drawer of the flashing indicator. Load paper.
The set paper size is different from that of the paper used. Check the paper size
setting and the actual paper size, and set the paper size to the size of the actual
paper or use a paper of the set size.
The tape in the developing section has not been removed. (See the installation
manual.)
Page
6-6
6-7
6-1
6-7
3-7
––
7-4
3-1
3-3
6-2
6-3
6-7
––