Filter
Top Products
CHAPTER 7 WHEN A PROBLEM OCCURS
Indication
“E70” appears on the copy quantity display.
“E71” appears on the copy quantity display.
“E72” appears on the copy quantity display.
“E90” appears on the copy quantity display.
“J96”, “J97”, “J98” or “J00” appears on the
copy quantity display.
“OP” appears on the copy quantity display.
“OP1” appears on the copy quantity display.
“OP2” appears on the copy quantity cover.
Action
While using the DF, the last of the ejected originals failed to be copied. Set that
original back onto the original table and resume the copying operation.
Originals that were not copied can be copied. Set all the ejected originals back
onto the original table and resume the copying operation.
While using the DF, an original is still in the original insertion section. Remove
that original and set it back onto the original table and then resume the copying
operation.
The memory is full.
To make copies of the scanned originals:
Press the Enter key. All the scanned originals will be copied. When copying
ends, set the remaining originals and press the Start key. The copying operation
resumes.
To make copies from the beginning again:
Press the Reset key, reduce the number of originals and repeat copying
operation again.
Open the drawer and left cover and check for any misfed paper. If the same
indication appears, contact your service representative.
The front or left cover is open. Close the cover.
The DF original switchback cover is open. Close the cover.
The left cover of the optional drawer is open. Close the cover.
Page
7-7
7-8
7-7
7-8
7-7
7-8
––
7-4
––
––
––
7-3