Filter
Top Products
10-2
Troubleshooting > Indicators During Sending/Receiving Operation
Indicators During Sending/Receiving Operation
The Processing and Memory indicators show the fax transmission status.
•The processing indicator blinks during fax transmission and reception.
•The Memory indicator blinks when source data is being stored in memory for memory transmission.
•The Memory indicator is lit when there is source data stored in the memory for delayed transmission.
•
Responding to an Attention Indicator Flashes
If an attention indicator flashes, press [Status/Job Cancel] to check an error message. If the message is not indicated on
the touch panel when [Status/Job Cancel] is pressed or the attention indicator flashes for 1.5 seconds, check the
following.
Symptom Checkpoints Corrective Actions Reference
Page
Cannot send fax. Is the modular cord connected
correctly?
Connect the modular cord correctly. —
Is Permitted FAX No. or
Permitted ID No. registered
correctly?
Check Permitted FAX No. and Permitted
ID No.
9-10
Has a communication error
occurred?
Check error codes in the TX/RX Result
Report and Activity Report. If the error
code starts with "U" or "E", perform the
corresponding procedure.
10-5
Is the destination FAX line busy? Send again. —
Does the destination FAX
machine respond?
Send again. —
Is there an error other than
above?
Contact your Service Representative. —