Filter
Top Products
INSTALLATION REQUIREMENTS
User Manual VanLink System featuring TouchStar™ Technology - Troll Systems Corporation
2-4 Document VLSG-01 - 10/21/08
2.3.3.3 Pan and Tilt Cabling and Connector Requirements
The pan and tilt cable and connector requirements are as follows (refer to Figure 2–2):
Twelve (12)
Wire Nycoil
• The pan/tilt controller is connected directly to the QPT pedestal on the roof via a
terminal strip in the rear of the controller.
— An additional four (4) wires are required for azimuth/elevation feedback.
— The four (4) wires will connect to the V750 or to the pan/tilt controller depending
on whether or not the model has feedback capability.
— For installations using the C90VS-DC115A, the 4 wires will terminate at the 26p
circular connector on the rear of the V750.
Figure 2–2. Typical Network Configuration