Filter
Top Products
Warning! Your LaCie drive is not compatible with HVD devices or buses! Never connect your LaCie drive to an
HVD bus or peripheral. Doing so may damage your drive and/or system, and will void your warranty.
LVD (Low Voltage Differential) – This latest addition to the SCSI interface, which became important with Ultra2 SCSI,
combines all of the advantages of SE and HVD. LVD has rapidly become the de facto standard in high-performance SCSI. Its
benefits include increasingly lower cost, more and more widespread use, enhanced reliability, higher data transfer rates,
compatibility with the newest high-speed hard drives, longer cable lengths than SE (up to 12 m), and backwards
compatibility with older SCSI technologies.
The following table shows the different types of SCSI implementations:
Fundamental SCSI rules
Follow these seven basic rules when setting up your SCSI peripheral or chain.
1) Give each SCSI peripheral a unique ID number.
Each device in your SCSI chain needs a unique ID number, either from 0 to 6 for Narrow SCSI, or any number between
0-6 and 8-15 for Wide SCSI (ID 7 is generally reserved for your computer’s SCSI controller). No two devices in the same
chain may have the same ID number, but the order in which the devices are connected in the bus does not matter. For
example, the device with ID 2 could be physically located at the end of the chain, while the device with ID 6 is connected
directly to the SCSI port of your computer.
2) Always terminate your SCSI chain.
The last device in your SCSI chain must be terminated. Even if you have only one SCSI peripheral in your chain, you must
terminate it. Single-ended SCSI devices may have an internal terminator (using an on/off switch) or may require an
external terminator.
Warning! LVD devices always require external termination. Consult your computer supplies specialist for a
terminator that meets your needs.
Technical Information
page 18
LaCie d2 SCSI Hard Drive
Category
Narrow (8 bit) Wide (16 bit) Wide (16 bit) Wide (16 bit) Wide (16 bit)
SCSI types
Fast SCSI Ultra Wide SE Ultra2 Wide (LVD) Ultra 160 (LVD) Ultra 320 (LVD)
Transfer rate
10MB/s max 40MB/s max 80MB/s max 160MB/s max 320MB/s max
# of devices
8 max 16 max 16 max 16 max 16 max
Cable length
3 m max 1.5 m max 12 m max 12 m max 12 m max
Connectors
25 or 50-pin 68-pin 68-pin 68-pin 68-pin