Filter
Top Products
LANCOM 7111 VPN – LANCOM 8011 VPN
̈ Chapter 2: Installation
20
EN
̈ Flashing means, that the LED lights up very briefly in the respective col-
our and stay then clearly longer (approximately 10x longer) switched off.
̈ Inverse flashing means the opposite. The LED lights permanently in the
respective colour and is only briefly interrupted.
̈ Flickering means, that the LED is switched on and off in irregular inter-
vals.
Power ³
This LED indicates that the device is operational. After the device has been
switched on, it will flash green for the duration of the self-test. After the self-
test, either an error is output by a flashing red light code or the device starts
and the LED remains lit green.
The power LED flashes red/green in alternation until a configuration
password has been specified. Without a configuration password, the
configuration data of the LANCOM is insecure. Under normal circum-
stances, you would assign a configuration password during the basic
configuration (see instructions in the following chapter). For informa-
tion about a later assignment of the configuration password see the
section ’Security settings’ →page 62.
Online ·
The Online LED indicates the overall status of all WAN ports:
off Device off
green blinking Self-test when powering up
green constantly on Device ready for use
red/
green
blinking alternately Device insecure: configuration password not assigned
red blinking Time or connect-charge reached
off No active connection
green flashing Establishing first connection
green inverse flashing Establishing further connection
green constantly on At least one connection established
red constantly on Error establishing the previous connection